OEM/ODM Supplier Flood Solution - Surface type Automatic flood barrier for Metro – JunLi

Short Description:

Product Detail

FAQ

Product Tags

Feedback (2)

As for competitive selling prices, we believe that you will be searching far and wide for anything that can beat us. We will state with absolute certainty that for such excellent at such charges we are the lowest around for Flood Solution , Flood Dam , Quick Dam Flood Protection Gate , We adhere on the tenet of Services of Standardization, to meet Customers' Demands.

OEM/ODM Supplier Flood Solution - Surface type Automatic flood barrier for Metro – JunLi Detail:

Model	water retaining height	Installation mode	bearing capacity
Hm4d-0006E	620	surface mounted	(pedestrian only)metro type

Scope of application

Grade	Mark	Bearing capacity (KN)	Applicable occasions
Metro type	E	7.5	Metro entrance and exit.

The Model Hm4d-0006E hydrodynamic automatic flood barrier is applicable to the entrance and exit of subway or metro train stations where allow for pedestrian only.

(1) Surface installation location

a ) It is about 5cm high from the ground. Need to prevent it from scratching the vehicle bottom when the vehicle is fully loaded. When the car is fully loaded, the minimum ground clearance: Pentium B70 = 95mm, Honda Accord = 100mm, Feidu = 105mm, etc.

b) )The location should be on the horizontal section at the top of the ramp, the inside of the outermost intercepting ditch, or installed on the intercepting ditch. Reasons: small water can be discharged through intercepting ditch; it can prevent backflow from intercepting ditch after municipal pipeline is full.

c)The higher the installation location, the higher the water retaining level.

(1) The levelness of the installation surface

a) The installation surface horizontal height difference at the end of the wall on both sides ≤ 30mm (measured by laser level meter)

(2) The flatness of the installation surface

a) According to code for acceptance of construction quality of building ground engineering (GB 50209-2010), the surface flatness deviation shall be ≤ 2mm (measured with 2m guiding rule and wedge feeler gauge), otherwise, the ground shall be leveled first, or the bottom frame will leak after installation.

b) In particular, the ground with anti-skid treatment shall be leveled first.

Product detail pictures:

Related Product Guide:

Sticking to the principle of Super Quality, Satisfactory service ,We are striving to be a good business partner of you for OEM/ODM Supplier Flood Solution - Surface type Automatic flood barrier for Metro – JunLi, The product will supply to all over the world, such as: Jamaica , Poland , Wellington , If any item be of interest to you, you should let us know. We will try our best to satisfy your requirements with high quality goods, the best prices and prompt delivery. You should feel free to contact us at any time. We will reply you when we receive your inquiries. Make sure you note that samples are available before we start our business.

We are a small company that has just started, but we get the company leader's attention and gave us a lot of help. Hope we can make progress together!