OEM Supply Automatic Flood Door For Subway - Embedded flood barrier for garage – JunLi

Short Description:


Product Detail

FAQ

Product Tags

Related Video

Feedback (2)

Our corporation puts emphasis about the administration, the introduction of talented staff, plus the construction of team building, attempting hard to improve the quality and liability consciousness of team members. Our organization successfully attained IS9001 Certification and European CE Certification of Automatic Flood Barrier Without Electricity , Water Fence Barrier , Quick Dam Water Activated Barrier , Welcome to visit our firm and factory. Be sure to come to feel free to get in touch with us in case you need any additional assistance.
OEM Supply Automatic Flood Door For Subway - Embedded flood barrier for garage – JunLi Detail:

Model water retaining height installation mode installation groove section bearing capacity
Hm4e-0012C  1150 embedded installation width1540 * depth: 105  heavy duty (small and medium-sized motor vehicles, pedestrian)

 

Grade Mark Bearing capacity (KN) Applicable occasions
Heavy duty C 125 underground parking lot, car parking lot, residential quarter, back street lane and other areas where only allow non-fast driving zone for small and medium-sized motor vehicles (≤ 20km / h).

Regular maintenance and inspection for the automatic flood barrier

Warning! This equipment is an important flood control safety facility. The user unit shall designate professional personnel with certain mechanical and welding knowledge to conduct regular inspection and maintenance, and shall fill in the inspection and maintenance record form (see the attached table of the product manual) to ensure that the equipment is in good condition and normal use at all times! Only when the inspection and maintenance are carried out in strict accordance with the following requirements and the “inspection and maintenance record form” is filled in, can the company’s warranty terms take effect.

1 ) [important] every month and before each heavy rain, manually pull and place the door leaf at least once, and clean up the sundries in the bottom frame! In order to prevent the door leaf from being stuck by foreign matters and unable to be opened normally; at the same time, the sediment, leaves and other sundries inside the bottom frame and water inlet shall be cleaned up to prevent the water inlet channel (GAP) from being blocked after the door leaf is closed, which hinders the flow of water and can not produce buoyancy, resulting in the door leaf not being able to automatically open and block the water; the deposited sediment, leaves and other sundries will accelerate the corrosion and shorten the service life of the equipment. When the door leaf is opened, the warning light shall flash at high frequency.

1) [important] conduct water injection test at least once a year before flood season! At the front of the flood control barrier, sandbags or manual plates are used to make the dam enclosure, and the drainage switch at the rear under the bottom frame is closed with tools such as screwdrivers. Water is poured in between the dam enclosure and the flood control barrier. The door leaf shall be able to automatically do the water retaining, and there is no obvious water leakage as a whole, and the warning light shall flash at high frequency. In case of surface installation on the slope, the drain switch shall be turned on after the test.

1 (1)

5


Product detail pictures:

OEM Supply Automatic Flood Door For Subway -
 Embedded flood barrier for garage – JunLi detail pictures

OEM Supply Automatic Flood Door For Subway -
 Embedded flood barrier for garage – JunLi detail pictures

OEM Supply Automatic Flood Door For Subway -
 Embedded flood barrier for garage – JunLi detail pictures


Related Product Guide:

Our business aims to operating faithfully, serving to all of our clients , and working in new technology and new machine continuously for OEM Supply Automatic Flood Door For Subway - Embedded flood barrier for garage – JunLi, The product will supply to all over the world, such as: Canberra , Seattle , United States , So far our products have been exported to east Europe, the Middle East, Southeast, Africa and South America etc. We have 13years professional sales and purchase in Isuzu parts at home and abroad and the ownership of the modernized electronic Isuzu parts checking systems. We honor our core principal of Honesty in business, priority in service and will do our best to offer our customers with high quality products and excellent service.

A good manufacturers, we have cooperated twice, good quality and good service attitude.
5 Stars By Hulda from Swaziland - 2017.09.22 11:32
The company comply with the contract strict, a very reputable manufacturers, worthy a long-term cooperation.
5 Stars By Jonathan from belarus - 2017.10.13 10:47