OEM Manufacturer Anti-Flood Flood Bag - Surface type Automatic flood barrier for Metro – JunLi

Short Description:

Product Detail

FAQ

Product Tags

Feedback (2)

We're commitment to offer you the aggressive cost ,superb products and solutions top quality, too as fast delivery for Home Quick Dam , Lift-Out Flood Barrier For Residential Building , Quick Dams For Subway , Should you be fascinated in any of our products and services, remember to do not hesitate to make contact with us. We're ready to reply you inside of 24 several hours soon after receipt of one's ask for and also to develop mutual un-limited advantages and organization in around potential.

OEM Manufacturer Anti-Flood Flood Bag - Surface type Automatic flood barrier for Metro – JunLi Detail:

Model	water retaining height	Installation mode	bearing capacity
Hm4d-0006E	620	surface mounted	(pedestrian only)metro type

Scope of application

Grade	Mark	Bearing capacity (KN)	Applicable occasions
Metro type	E	7.5	Metro entrance and exit.

The Model Hm4d-0006E hydrodynamic automatic flood barrier is applicable to the entrance and exit of subway or metro train stations where allow for pedestrian only.

(1) Surface installation location

a ) It is about 5cm high from the ground. Need to prevent it from scratching the vehicle bottom when the vehicle is fully loaded. When the car is fully loaded, the minimum ground clearance: Pentium B70 = 95mm, Honda Accord = 100mm, Feidu = 105mm, etc.

b) )The location should be on the horizontal section at the top of the ramp, the inside of the outermost intercepting ditch, or installed on the intercepting ditch. Reasons: small water can be discharged through intercepting ditch; it can prevent backflow from intercepting ditch after municipal pipeline is full.

c)The higher the installation location, the higher the water retaining level.

(1) The levelness of the installation surface

a) The installation surface horizontal height difference at the end of the wall on both sides ≤ 30mm (measured by laser level meter)

(2) The flatness of the installation surface

a) According to code for acceptance of construction quality of building ground engineering (GB 50209-2010), the surface flatness deviation shall be ≤ 2mm (measured with 2m guiding rule and wedge feeler gauge), otherwise, the ground shall be leveled first, or the bottom frame will leak after installation.

b) In particular, the ground with anti-skid treatment shall be leveled first.

Product detail pictures:

Related Product Guide:

All we do is usually affiliated with our tenet Buyer to start with, Belief to start with, devoting about the food packaging and environmental defense for OEM Manufacturer Anti-Flood Flood Bag - Surface type Automatic flood barrier for Metro – JunLi, The product will supply to all over the world, such as: Iraq , Romania , Saudi Arabia , Our company insists on the purpose of takes service priority for standard, quality guarantee for the brand, do business in good faith, to provide professional, rapid, accurate and timely service for you. We welcome old and new customers to negotiate with us. We will serve you with all sincerity!